· Electronic speed control
· Oil cooler with hydraulic driven fan
· Breakout wrench hydraulic cylinder
· Front hydraulic outrigger jack
· Extended mast height
· Wireless remote control
· Mast lights
· Walking beam
· Special paint colors
· Line-X spray-on bed liner
· Headache rack
· Towing hitch
· Power to the rear. Maximum 25 GPM @ 2,250 psi
· Other options are available on request
The R12 pump hoist with 44,000 lbs. capacity and a 44 ft. high telescoping mast is designed for fast and easy setup by means of a self supporting mast with two 4 1/2" bore hydraulic cylinders. A guy cable is not needed in most situations. Designed to allow for easy access to hard-to-get-to pumps.
Mast: 44 ft. high telescoping mast with 10 ft. maximum layback
Capacity: 11,000 lbs. single line, 44,000 lbs. with 4 part line
Mainline speed: 120 feet per minute
Mainline cable: 5/8" X 280'
The mainline spool is driven by 2 heavy duty pinion gears with the pinion shafts direct coupled to 2 hydraulic motors. Braking is accomplished with 2 Hunke automatic fail safe brakes. Hunke's unique rigging on the main winch allows changing from a 4 part line to a 2 part line with minimal time and effort.
The tailout winch has a 3,000 lb. lifting capacity at 100 feet per minute and uses a fail-safe brake. Tailout cable: 3/8"
Line block: 2 sheave block with bearings for 4 part line, hook not included
PTO for standard transmission
Hydraulic pump: 3 stage gear pump
Corded remote control
The deck is an integral part of the R12 rig. A Hunke deck of 17 ft. minimum length is required.
Operating controls are conveniently located at the left rear corner of the rig and are accessible from ground level
Hydraulic bypass valves are incorporated to protect from overloading
Rear hydraulic outriggers with holding valves
Holding valve on mast cylinders
White or gray paint on the mast and black paint on the deck and rig frame
Sandline winch: The sandline winch can be switched between a 7,000 lb. bare spool lifting capacity with maximum speed of 200 feet per minute or 3,500 lb. bare spool capacity with 400 feet per minute line speed. It is power-up and power-down. Braking is accomplished with 2 automatic fail safe brakes. Spool capacity: 1,900 ft. of 1/2" cable, 2,500 ft. of 7/16", or 3,400 ft. of 3/8" cable.