· Electronic speed control
· Pipe racks
· Oil cooler
· Cathead
· Breakout wrench hydraulic cylinder
· Front hydraulic outrigger jack
· Extended mast height
· Corded remote control
· Wireless remote control
· Tailgate
· Rear bumper
· Receiver hitch

· Toolboxes
· Mast lights
· Walking beam
· Special paint colors
· Line-X spray-on bed liner
· Utility body
· Deck
· Headache rack
· Wire winder
· Plastic pipe reel
· Power to the rear
· Other options are available on request

Product Description:

The 8T pump hoist with 21,000 lbs. capacity and a 36 ft. high telescoping mast is designed to mount on a 2 ton or larger truck. Fast and easy setup by means of a self supporting mast with two 3 1/2" bore hydraulic cylinders. A guy cable is not needed in most situations. Designed to allow for easy access to hard-to-get-to pumps. Total pump hoist weight is approximately 5,300 lbs. A deck, headache rack and toolboxes add approximately 3,000 lbs. 

 

Standard features: 

Mast: 36 ft. high telescoping mast with 10 ft. maximum layback
Capacity: 7,000 lbs. single line, 21,000 lbs. with 3 part line
Mainline speed: 120 feet per minute
Mainline cable: 5/8" X 150'
The mainline spool is driven by a heavy duty pinion gear with the pinion shaft direct coupled to the hydraulic motor.  Braking is accomplished with a Hunke automatic fail safe brake.
The tailout winch is worm gearbox driven with a 2,000 lb. lifting capacity at 70 feet per minute.  Tailout cable: 3/8" x 125 ft.
Line Block: Blocks for reeving a 2 part or 3 part line
Hooks: 7 ton and 15 ton safety hooks
PTO for standard transmission (PTO is available for an automatic at additional cost)
Hydraulic pump: 2 stage gear pump
The pump hoist may be mounted in a 54" x 11' utility body or on a deck
Open frame design allows for full use of the deck area 
Operating controls are conveniently located at the left rear corner of the rig and are accessible from ground level 
Hydraulic bypass valves are incorporated to protect from overloading
Rear hydraulic outriggers with holding valves
Holding valve on mast cylinders
White or gray paint - Standard

 

Optional features: 

Sandline winch: 2,500 lb. bare spool lifting capacity with 325 feet per minute line speed. It is power-up and power-down. Braking is
accomplished with a Hunke automatic fail safe brake. Spool capacity: 800 ft. of 1/2 in. cable, 1,100 ft. of 7/16 in. cable, or 1,500 ft. of 3/8 in. cable.