The 12,000 lb. capacity 5T is the most popular pump hoist. It is extremely versatile with capabilities ranging from small submersible pumps all the way up to line shaft turbines. Fast and easy setup by means of a self supporting mast with two 3 1/2" bore hydraulic cylinders. A guy cable is not needed in most situations. Designed to allow for easy access to hard-to-get-to pumps and windmills. The 5T is designed to mount on 1 ton or larger truck. Weight is approximately 2,400 lbs.
Mast: 36 ft. high telescoping mast with 11 ft. maximum layback
Capacity: 3,000 lbs. single line, 12,000 lbs. with 4 part line
Mainline speed: 120 feet per minute
Mainline cable: 7/16" X 220' with open spelter socket
The mainline spool is driven by a heavy duty pinion gear with the pinion shaft direct coupled to the hydraulic motor. Braking is accomplished with a Hunke automatic fail safe brake.
Line Block: Blocks for reeving a 2 part, 3 part, or 4 part line
Hook: 5 ton safety hook
PTO for standard transmission with direct mounted pump (PTO is available for an automatic transmission at additional cost)
Hydraulic pump: Gear pump
The pump hoist may be mounted in a 48" x 9' utility body or on a deck
Open frame design allows for full use of the deck area
Operating controls are conveniently located at the left rear corner of the rig and are accessible from ground level
Hydraulic bypass valves are incorporated to protect from overloading
Rear hydraulic outriggers with holding valves
Holding valve on mast cylinders
White or gray paint - Standard
Sandline winch: 1,000 lb. bare spool lifting capacity with 325 feet per minute line speed. It is power-up and power-down and also incorporates a heavy duty clutch for free-fall. Braking is accomplished with a Hunke automatic fail safe brake. Spool capacity: 1,650 ft. of 1/4" cable, 1,050 ft. of 5/16" cable or 740 ft. of 3/8" cable.