· Electronic speed control
· Breakout wrench hydraulic cylinder
· Front hydraulic outrigger jacks
· Extended mast height
· Mast lights
· Walking beam
· Special paint colors
· Line-X spray-on bed liner
· Headache rack
· Towing hitch
· Power to the rear. Maximum 25 GPM @ 2,250 psi
· Other options are available on request
The 50T pump hoist with 100,000 lbs. capacity and a 44 ft. high telescoping mast is designed for fast and easy setup by means of a self supporting mast with four 5" bore hydraulic cylinders. A guy cable is not needed in most situations. Designed to allow for easy access to hard-to-get-to pumps.
Mast: 44 ft. high mast with 6 ft. maximum layback
Capacity: 14,000 lbs. single line, 100,000 lbs. with 8 part line
Mainline speed: 300 feet per minute
Mainline cable: 3/4"
The mainline winch is hydrostatically driven with infinite variable control for exceptionally smooth operation. The motor includes an internal winch brake.
The tailout winch has a 3,000 lb. lifting capacity at 100 feet per minute and uses a fail-safe brake. Tailout cable: 3/8"
Line block: 4 sheave block with bearings for 8 part line, hook not included
PTO for standard transmission
Hydraulic pump: Hydrostatic pump
Oil cooler with hydraulically driven fan
Corded remote control
The deck is an integral part of the 50T rig. A Hunke deck of 22 ft. minimum length is required.
Operating controls are conveniently located at the left rear corner of the rig and are accessible from ground level
Hydraulic bypass valves are incorporated to protect from overloading
Rear hydraulic outriggers with holding valves
Holding valve on mast cyliners
White or gray paint on the mast and black paint on the deck and rig frame
Sandline winch: The sandline winch uses the same type and size hydrostatic motor as the main winch. The motor includes an internal winch brake. Bare spool capacity is 13,000 lbs. at 300 feet per minute line speed. Spool capacity: 3,000 ft. of 9/16" cable.